Shipping all 7 days! Hold times are long. Already ordered? Email [email protected]Learn more
Home>Shop for Parts

Shop Maytag Washer/Dryer Combo Parts

2,284 results
Sort:
Go
Watch Video
$17.76

Dryer thermal fuse located on the blower housing. If the dryer overheats, the thermal fuse blows cutting off power to the motor or the heating system. When the fuse is bad the dryer won't start or will run but not heat. The thermal fuse cannot be reset. Fuses often blow due to a clogged dryer vent.

Watch Video
$20.96

Dryer drum drive belt. The belt is flat, 92-1/4 inches long, 1/4 inch wide and has 4 ribs and 3 grooves. It replaces many other belts, including some with 5 ribs and 4 grooves. If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.

Watch Video
$27.05

Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

Watch Video
$61.21

Dryer heating element. If your dryer does not heat first check for a blown thermal fuse on the blower housing before replacing the heating element. In most cases the heating element will have a break in the element if defective. *May need wire connector to install heating element.

Watch Video
$28.75

Dryer drum support roller kit. Includes two washers. When the drum rollers are worn out, they can cause the dryer to make a loud rumbling noise. Both rollers should be replaced at the same time. The roller does not need lubrication, the bearing is self-lubricating.

Watch Video
$31.00

Dryer idler pulley assembly. Includes bracket and attached pulley

Watch Video
$51.57

Repair kit for Whirlpool, Kenmore, Roper dryer; rollers, belt and idler pulley, for 29" wide Dryers built 1965 and later. This dryer maintenance kit contains all of the parts that are commonly defective when the dryer is noisy.
-Call with model# to verify if kit is compatible with your dryer.

Watch Video
$48.79

Dryer heating element thermal cut-off (thermal fuse) 309 degrees and high limit thermostat 250 degrees, with wiring kit. If the dryer does not heat the thermal cut off may have blown and a new high limit thermostat is needed.

Watch Video
$5.13

Washing machine agitator directional cogs. These parts are also referred to as "dog ears." 4 per package. If the upper section of the agitator isn't turning properly, then these cogs are likely worn and will require replacement.

Watch Video
$27.82

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Watch Video
$25.14

Washer drive motor coupler. New style with metal sleeves for added strength. This version replaces all previous motor coupler styles and versions. For direct drive washing machines. Common symptom of failed coupler is washer will fill, not agitate or spin but will drain the water from the tub.

Watch Video
$29.42

Dryer door switch assembly. If the dryer does not start then the door switch could be defective. This switch also replaces the two wire switch.

Watch Video
$31.27

Dryer drum drive belt, 93 1/2 inches long, 4 ribs 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Watch Video
$33.08

Dryer drum drive belt, 100 inches long, 3/8" wide,5 ribs 4 grooves. The drive belt wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Watch Video
$29.52

Dryer cycling thermostat with internal bias heater, L155-25. If the dryer won't heat, it is unlikely that this thermostat is causing the issue, as the thermal fuse or thermal cut-out normally fail first.

Go

Quality Maytag Washer/Dryer Combo Replacement Parts From Repair Clinic

You probably purchased your Maytag Washer/Dryer combo because it’s a compact, reliable choice when living space is at a premium. Repair Clinic also believes in keeping things manageable, which is why our website stocks all the replacement parts you need to repair your washer/dryer combo yourself, and a whole lot of repair support as well. If your dryer doesn’t start, the thermal fuse may have blown. Keep in mind, a blown thermal fuse is usually caused by the dryer venting getting clogged with lint, so make sure to clean out the venting regularly. Faulty start switches or door switches may be preventing the dryer or the washer from starting as well. Repair Clinic has all these parts, along with fill hoses, drain hoses, drum belts; everything to keep your Maytag Washer/Dryer combo doing its double duty.

Just be sure to enter the full model number of your Maytag appliance in our website’s search bar to find the specific part that matches your model. If you need additional help finding the right part, you can always call our Customer Service Team at 1-800-269-2609. Be sure to check out the Repair Help section of Repair Clinic.com for help diagnosing the problem you may be experiencing with your washer/dryer combo. The thousands of diagrams, schematics, and "step-by-step” repair videos will go a long way in building your confidence to handle any repair.