Dryer door catch kit. This kit includes three different door catches; you will need to select the door catch that fits your model.
Rear drum support roller kit. This kit contains two drum support rollers. If the drum rollers are worn out, the dryer may not turn properly or may be excessively noisy. Be aware that the drum bearings are self-lubricating; it is not necessary to lubricate them yourself.
Washing machine drain pump. The pump mounts directly to the motor with two clips. If the washer does not drain then the pump could be locked up or a small object may be clogging it. A small leak in front of the washer could be caused by a defective pump.
Washing machine agitator repair kit with a medium length cam (there are other kits available for different models). This kit should be used when the top part of the agitator is not moving properly but the bottom part is.
Dryer drum drive belt. Length 93 3/8”, width 3/8”, characteristics, 5 ridges, flat. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley.
Dryer belt tension idler pulley assembly.When the idler pulley goes bad it will usually make a high pitch squeeling or rattling noise.
Drive Clutch Kit. This kit has 6 parts; a spring, housing, cam ring, basket drive gear, pulley, and nut. The pulley is driven by the drive belt and the splutch works with the mode shift actuator to operate the washplate and spin the inner basket. A worn splutch can cause spin or washplate problems.
Washing machine clutch assembly with hardware. *Blue spring for regular, large, extra and super capacity washers, black for compact models. A worn clutch often causes a slower spin speed which leaves the clothes soaked after the cycle.
Washing machine suspension spring. If the suspension spring is broken, the washer will be off balance.
Dryer lint screen assembly. Proper air flow is critical to dryer operation so the filter should be cleaned before every load.
Washing machine water inlet valve kit with bracket. A long or slow fill cycle is often due to a restricted water valve. The valve should never be disassembled and cleaned, only replaced.
Dryer drive belt. The belt has a length of 91 5/8” and width 5/16”. The belt has 5 ridges. If the dryer drum won’t rotate, but the motor is running then the belt has likely broken.
Dryer drum support roller. The rollers tend to wear at the same rate so both should be replaced while the dryer is apart.
Dryer lint filter. Air flow is vital to proper dryer operation. The lint filter should be cleaned before every load and replaced if damaged.
Dryer heating element assembly. If the dryer does not heat the thermal fuse should be checked before replacing the heating element. Normally, the element will have a break in the coil if defective.