Pressure washer thermal release valve. This valve will open to prevent excessive heat and pressure buildup in the pump.
Chemical injection kit for pressure washer pump. Be sure to use the lowest pressure nozzle when adding chemicals to the spray.
Walbro primer bulb. The primer bulb draws additional fuel into the carburetor to make the engine easier to start. If the primer bulb is leaking, replace it.
Pressure washer high pressure hose, 25 ft. This hose can be used on pumps that produce up to 3000 PSI.
Pressure washer pump assembly. If the pressure washer is leaking water, the pump may need to be rebuilt or replaced. This pump does not include a new thermal release valve and key. You will need to reuse the old thermal release valve and drive key or purchase new ones.
Wheel 12 x 175 1/2 hub - 5 spo
Briggs & Stratton Pressure Washer Pump Saver. 4 oz.
Inlet tube connector
In-line fuel filter
Output shaft key
Fuel tank bumper.
Homelite two cycle engine carburetor gasket. If the gasket is torn or damaged the engine may run rough.