Flame rollout limit switch, re-settable. opens at 250f
Dual Capacitor, 45+ 5 MFD, 440 volts
Carrier furnace igniter. The igniter gets very hot and glows bright orange to light the gas burner. If the igniter is cracked or defective, the furnace won’t heat.
Furnace draft inducer mounting grommet. This grommet helps isolate the blower assembly from the furnace to reduce noise.
Furnace draft inducer motor cooling fan blade and clip. You may have to cut the old clip off to remove the fan blade.
Nitride Hot Surface Furnace Ignitor
Flame rollout limit switch re-settable 350F
Contactor. 1 pole, 24 volts, 30 amps.
Dual run capacitor round 440 V 35/5 uF
Gas burner tube
Furnace draft inducer motor with cooling fan. Be aware that the screw holes are not threaded—you will need to use self-tapping screws to install the motor.
Inducer fan wheel
Gas furnace flame sensor
Limit switch non-resettable 101-200F