Flame rollout switch 300F resetable
Control fan timer
Triple-D Coil Cleaner is a 19oz Aerosol spray can, that is safe for homeowner use. One can will clean an entire outdoor condenser coil and/or indoor evaporator coil, to remove energy-stealing dirt, debris and soot.
Contactor 1 pole 25 amp 24 volt
Furnace burner igniter and flame sensor assembly. This is a 24 volt igniter.
Condenser fan motor. This single-phase motor has the following specifications:
Full-Load Amperage: 1.3
Shaft Length: 2.5”
Single run capacitor, oval, 370 volts, 10 microfarads
3 Blade fan, 18" diameter 28 degree 1/2" CW
Hot surface furnace igniter kit.
If the electrical connnector on your old part is different than the new igniter, it can be cut off and spliced onto the new igniter wires using the provided wire nuts.
Tube silicone 24" x 1/4"id
* 16 foot lift
* Whisper quiet
* ½ Gallon Reservoir
* Rubber isolation feet
* 3/8" Check Valve
Pilot and spark igniter assembly
Pilot spark igniter and flame sensor assembly
3 Blade fan, 22" diameter 22 degree 1/2" CW