Make Selection Here:
RepairClinic Item # 2986
Dryer thermal fuse. Located on the blower housing. If the dryer overheats, the thermal fuse blows to cut off power to the dryer. If the thermal fuse has blown, the dryer won't start. The thermal fuse cannot be reset—if the fuse has blown, replace it. Thermal fuses often blow due to a clogged vent.
OEM Part - Manufacturer #WP3392519
RepairClinic Item # 529597
Dryer drum drive belt. The belt is flat, 92-1/4 inches long, 1/4 inch wide and has 4 ribs and 3 grooves. It replaces many other belts, including some with 5 ribs and 4 grooves. If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.
OEM Part - Manufacturer #341241
RepairClinic Item # 3479
Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.
OEM Part - Manufacturer #279834
RepairClinic Item # 2438
Dryer heating element. If your dryer does not heat first check for a blown thermal fuse on the blower housing before replacing the heating element. In most cases the heating element will have a break in the element if defective.
OEM Part - Manufacturer #279838
RepairClinic Item # 2651
Dryer heating element thermal cut-off (thermal fuse) 309 degrees and high limit thermostat 250 degrees, with wiring kit. If the dryer does not heat the thermal cut off may have blown and a new high limit thermostat is needed.
OEM Part - Manufacturer #279816
RepairClinic Item # 1958
40 Watt frosted appliance light bulb.
OEM Part - Manufacturer #8009
RepairClinic Item # 1925071
Drum support roller. Tri Rings are not included.
OEM Part - Manufacturer #WPW10314173
RepairClinic Item # 528948
Dryer door switch assembly. If the dryer does not start then the door switch could be defective. This switch also replaces the two wire switch.
OEM Part - Manufacturer #WP3406107
RepairClinic Item # 2754401
Dryer tri-ring retainer for drum support rollers.
OEM Part - Manufacturer #WPW10512946
RepairClinic Item # 4248258
Dryer drum drive belt, 93 1/2 inches long, 4 ribs 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.
OEM Part - Manufacturer #661570V
RepairClinic Item # 1206293
Dryer lint filter. Air flow is vital to proper dryer operation. The lint filter should be cleaned before every load and replaced if damaged.
OEM Part - Manufacturer #W10120998
RepairClinic Item # 2893
Dryer cycling thermostat with internal bias heater, L155-25. If the dryer won't heat, it is unlikely that this thermostat is causing the issue, as the thermal fuse or thermal cut-out normally fail first.
OEM Part - Manufacturer #WP3387134
RepairClinic Item # 1470216
Dryer door catch. If the dryer door does not latch closed then the door strike or this catch is likely damaged.
OEM Part - Manufacturer #WPW10111905
RepairClinic Item # 3415
Dryer igniter kit. This igniter will replace both round and flat style igniters. The kit includes the bracket, wire nuts and mounting screw. Be aware the igniter is very fragile and should be handled carefully.
OEM Part - Manufacturer #279311
RepairClinic Item # 2958
Dryer idler pulley. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin.
OEM Part - Manufacturer #279640
RepairClinic Item # 525502
Dryer heating element assembly. If the dryer does not heat the thermal fuse should be checked before replacing the heating element. Normally, the element will have a break in the coil if defective.
OEM Part - Manufacturer #WP3387747
RepairClinic Item # 3436
Rear drum support roller kit. This kit contains two drum support rollers. If the drum rollers are worn out, the dryer may not turn properly or may be excessively noisy. Be aware that the drum bearings are self-lubricating; it is not necessary to lubricate them yourself.
OEM Part - Manufacturer #349241T
RepairClinic Item # 3493
Dryer door catch kit. This kit includes three different door catches; you will need to select the door catch that fits your model.
OEM Part - Manufacturer #279570
RepairClinic Item # 1181075
Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.
OEM Part - Manufacturer #WP8577274
RepairClinic Item # 898078
Dryer high-limit thermostat, L250-80, with terminal extension arm. This thermostat should be closed for continuity at room temperature and opens at around 250 degrees Fahrenheit. If the dryer won't heat, the high-limit thermostat might be defective.
OEM Part - Manufacturer #WP3977767
RepairClinic Item # 3346
Dryer belt tension idler pulley assembly.
OEM Part - Manufacturer #WP691366
RepairClinic Item # 3379136
Dryer lint screen assembly. Proper air flow is critical to dryer operation so the filter should be cleaned before every load.
OEM Part - Manufacturer #WPW10717210
RepairClinic Item # 2821
Heating element thermal cut-off (thermal fuse) 360 degrees and high-limit thermostat 250 degrees. The thermal fuse is a safety device designed to protect the dryer from overheating. A multimeter can be used to test the fuse. Always check the dryer venting when replacing a blown thermal fuse.
OEM Part - Manufacturer #279769
RepairClinic Item # 4380739
White door handle
OEM Part - Manufacturer #W10861225
RepairClinic Item # 4337602
Dryer idler pulley assembly.
OEM Part - Manufacturer #W10837240
RepairClinic Item # 2923
Dryer thermal fuse (or thermal limiter). This fuse is located on the exhaust duct. If the dryer overheats, the thermal fuse opens to cut off power to the dryer. The thermal fuse cannot be reset--if the thermal fuse is open, it must be replaced.
OEM Part - Manufacturer #WP3390719
RepairClinic Item # 2935192
Dryer L.P conversion kit Natural gas to LP (liquid propane). This kit includes the orifice, leak limiter, and instruction sheet.
OEM Part - Manufacturer #W10606694A
RepairClinic Item # 597440
OEM Part - Manufacturer #WP489483
RepairClinic Item # 3367
Dryer heating element assembly, 240 volts. If the dryer does not heat check for a blown themal fuse or thermal cut out. Heating elements will often have a break in the coil element if defective.
OEM Part - Manufacturer #WP4391960
RepairClinic Item # 897710
Dryer high limit thermostat and thermal fuse kit. If the dryer does not heat the most common cause is a blown thermal fuse. Both the thermostat and fuse can be tested to determine if either is defective.
OEM Part - Manufacturer #279973
RepairClinic Item # 3344
Dryer thermal fuse and high limit thermostat kit for both gas and electric models. If the dryer does not heat then the thermal fuse may have blown and will need to be replaced.
OEM Part - Manufacturer #LA-1053
RepairClinic Item # 587636
Repair kit for Whirlpool, Kenmore, Roper dryer; rollers, belt and idler pulley, for 29" wide Dryers built 1965 and later. This dryer maintenance kit contains all of the parts that are commonly defective when the dryer is noisy.
-Call with model# to verify if kit is compatible with your dryer.
OEM Part - Manufacturer #4392065
RepairClinic Item # 2681
Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.
OEM Part - Manufacturer #WP338906
RepairClinic Item # 4338557
Lint Filter with Cover
OEM Part - Manufacturer #W10828351
RepairClinic Item # 1939021
Dryer LP (liquid propane) conversion kit. From Natural gas to LP.
OEM Part - Manufacturer #49572A
RepairClinic Item # 1180054
Dryer heating element. If the dryer no longer heats then the heating element may have failed, but it is not the most common cause. The most common cause for a dryer to stop heating is a blown thermal fuse.
OEM Part - Manufacturer #WP8544771
RepairClinic Item # 2659
Lint filter with handle, measures 20 3/4" x 7 1/2". This filter should be cleaned before every load to ensure proper airflow for dryer operation. If the lint filter is ripped or torn, replace it.
OEM Part - Manufacturer #WP349639
RepairClinic Item # 455007
Light bulb, 10 watt.
OEM Part - Manufacturer #WP22002263
RepairClinic Item # 1202371
Adjustable leveling leg for washing machine. This leveling leg has a rubber foot. If the leveling leg is not adjusted properly, the washer will be off-balance and will vibrate or shake during operation.
OEM Part - Manufacturer #WPW10001130
RepairClinic Item # 4262694
Dryer lint screen assembly with handle
OEM Part - Manufacturer #339392V
RepairClinic Item # 525385
Dryer moisture sensor bar. This moisture sensor monitors the clothing’s moisture level and sends a signal to the control board when the clothes are dry. If your moisture sensor is defective, the dryer may shut off too early or continue running for a while after the clothes are dry. Two required.
OEM Part - Manufacturer #WP3387223
RepairClinic Item # 1201488
Lint screen assembly
OEM Part - Manufacturer #WP8572270
RepairClinic Item # 485585
OEM Part - Manufacturer #WP308685
RepairClinic Item # 2584
Dryer drum drive motor. Includes pulley for dryer drum drive belt. Other shaft has reverse threads for blower wheel. Common symptoms of a bad drive motor are:
-Dryer stops turning during cycle
-Dryer won't start
-Dryer won't turn at all
-Dryer drive motor is loud
OEM Part - Manufacturer #279827
RepairClinic Item # 1544893
Vacuum cleaner attachment for condenser and dryer cleaning - This long vacuum cleaner attachment will help to clean dust and lint build-up in and around your refrigerator condenser coils underneath the refrigerator and dryer lint in the area where the lint filter is inserted. Fits 1-1/4 inch vacuum
OEM Part - Manufacturer #8171579A
RepairClinic Item # 686172
Dryer blower wheel. Used on 29 inch Whirlpool built models with lint filter on top. To remove the blower wheel, unscrew the blower wheel clockwise off the motor shaft.
OEM Part - Manufacturer #WP694089
RepairClinic Item # 3227
Dryer lint filter (lint trap). Your lint filter should be replaced if it is torn or damaged in any way.
OEM Part - Manufacturer #WP53-0918
RepairClinic Item # 898073
Dryer push to start switch. If the dryer doesn't start then the start switch may be defective. The switch can be tested to determine it is bad using a multi-meter.
OEM Part - Manufacturer #WP3977456
RepairClinic Item # 906595
Control knob, gray
OEM Part - Manufacturer #WP8181859