Home>Shop for Parts

Shop Kenmore Dryer Parts

5,476 results
Sort:
Go
Watch Video
$11.41
24% Off MSRP: $14.95

Dryer thermal fuse located on the blower housing. If the dryer overheats, the thermal fuse blows cutting off power to the motor or the heating system. When the fuse is bad the dryer won't start or will run but not heat. The thermal fuse cannot be reset. Fuses often blow due to a clogged dryer vent.

Watch Video
$17.16

Dryer drum drive belt. The belt is flat, 92-1/4 inches long, 1/4 inch wide and has 4 ribs and 3 grooves. It replaces many other belts, including some with 5 ribs and 4 grooves. If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.

Watch Video
$49.51
17% Off MSRP: $59.95

Dryer heating element. If your dryer does not heat first check for a blown thermal fuse on the blower housing before replacing the heating element. In most cases the heating element will have a break in the element if defective. *May need wire connector to install heating element.

Watch Video
$17.24
21% Off MSRP: $21.80

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Watch Video
$13.81
14% Off MSRP: $16.10

Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

Watch Video
$30.26
24% Off MSRP: $39.95

Dryer heating element thermal cut-off (thermal fuse) 309 degrees and high limit thermostat 250 degrees, with wiring kit. If the dryer does not heat the thermal cut off may have blown and a new high limit thermostat is needed.

Watch Video
$6.73

Dryer drum slide. There are two of these needed on your dryer. These go on the inner most slots on the front bearing. Sold individually will need to purchase two*. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.

Watch Video
$22.43

Dryer door switch assembly. If the dryer does not start then the door switch could be defective. This switch also replaces the two wire switch.

Watch Video
$8.84

Dryer drum slide. There are two of these needed on your dryer. The dryer's drum slides help to support the front of the drum as it rotates. If the drum slides are worn out, the dryer will be noisy. Because the slides wear out at the same rate, we recommend replacing all of the slides together.

Watch Video
$6.41
46% Off MSRP: $11.90

Dryer drum roller. If the dryer is noisy the roller may be worn and requires replacement. The bearing in the roller is self-lubricating so no grease is needed

Watch Video
$7.85
61% Off MSRP: $19.95

Rear drum support roller kit. This kit contains two drum support rollers. If the drum rollers are worn out, the dryer may not turn properly or may be excessively noisy. Be aware that the drum bearings are self-lubricating; it is not necessary to lubricate them yourself.

Watch Video
$17.46
27% Off MSRP: $23.88

Dryer idler pulley assembly.

Watch Video
$22.26

Dryer drum drive belt, 93 1/2 inches long, 4 ribs 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Watch Video
$48.25

Repair kit for Whirlpool, Kenmore, Roper dryer; rollers, belt and idler pulley, for 29" wide Dryers built 1965 and later. This dryer maintenance kit contains all of the parts that are commonly defective when the dryer is noisy. <br>-Call with model# to verify if kit is compatible with your dryer.

Go

Quality Kenmore Dryer Parts From Repair Clinic

Kenmore gas and electric dryers are among the most energy-efficient appliances on the market. In order to keep them that way, you will probably need to do some maintenance or repairs from time-to-time. That’s where Repair Clinic can save you some money. Our huge inventory of Kenmore dryer replacement parts, combined with our repair help "know-how”, can assist you in keeping your dryer in efficient working order all on your own. If your dryer won’t start, it’s likely the thermal fuse has blown, or the door switch is defective. Repair Clinic has both parts available to ship. Gas dryer won’t heat? Could be a faulty gas valve solenoid. Electric dryer won’t heat? Might be a malfunctioning heating element. Again, Repair Clinic has the parts and they’re just a few clicks away.

Just be sure to enter the full model number of your Kenmore dryer in our website’s search bar to find the specific parts that match your model. If you need additional help finding the right parts, you can always call our Customer Service Team at 1-800-269-2609. While you’re here, check out our repair help library. We have thousands of schematics and “how-to” videos that will make it easy for you to install that part. You can pride yourself on doing it yourself, and save some money, too!