Washing machine drain pump. If the washer does not drain then the drain pump may be clogged, damaged, or defective.
Washer hot water inlet valve. Standard hose fitting inlet, 1 water outlet. The water inlet valve opens to allow water to enter the washing machine. If the water inlet valve is defective, the wash may fill slowly or not fill at all.
Washer cold water inlet valve assembly. Three solenoids. Hot water valve is a separate single coil valve and can be found in related parts
Dishwasher hinge cable. This cable connects the door hinge to the door spring.
Washing machine rotor position sensor assembly. This part is also called a hall sensor or motor sensor. When this part fails the control may display an LE error code.
Washer door lock latch assembly. The door lock secures the washer door shut during operation. Once the washing machine door is closed, the washer can begin operating. If the door lock is defective, the washer door will not latch properly.
Washer door magnet holder kit. Helps keep door open slightly when machine is not in use.
Washer tub bearing, rear. This part is very difficult to install. The manufacturer recommends replacing the complete rear tub and bearing assembly.
Dishwasher lower dishrack roller and axle assembly with mounting clip.
Washing machine tub seal. If the washing machine is leaking water from above the transmission, this seal is likely damaged or worn out.
Replacement dishwasher drain hose. Per the manufacturer if the drain hose being replaced does not have the vent tube going to the water inlet assembly a new water inlet will be needed. Please see Recommended Parts for water inlet information.
Washing machine drain hose with bellows. This drain hose makes a connection from the washer tub to the drain pump.
Dishwasher hinge spring. If the door feels heavy or is noisy while opening and closing then one or both of the door springs are likely defective.
Washing machine water inlet and dispenser valve assembly. If the washer does not fill properly the valve may be resticted and need replacement. We do not recommend taking inlet valves apart and trying to clean them due to the risk of failure after repair.