Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.
Dryer moisture sensor bar. This moisture sensor monitors the clothing’s moisture level and sends a signal to the control board when the clothes are dry. If your moisture sensor is defective, the dryer may shut off too early or continue running for a while after the clothes are dry. Two required.
Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.
Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.
Oven temperature sensor. The oven sensor works in conjunction with the oven control board to regulate the oven temperature. If the oven sensor is defective, the oven temperature will be inaccurate by more than 50 degrees Fahrenheit.
Air conditioner thermistor. The thermistor is a sensor connected to the control board that detects the temperature of the air. The ohm reading should be around 30k at a 75 degree room temperature.
Oven sensor kit, short 3" long
Oven temperature sensor kit, 6 inches long. The sensor includes two wire harness adapters for a variety of applications and installation instructions.
Temperature sensing thermistor
Turbidity (soil) sensor mounted in pump sump under dishwasher
Temperature sensor at evaporator in the freezer
Oven temperature sensor
Refrigerator/ freezer thermistor kit This kit no longer comes with instructions, Take the part number for the Kit and enter it at Servicematters.com for a copy of the instructions.