York Parts

Furnace control board. The control board regulates the supply of power to the furnace components.

OEM Part - Manufacturer #S1-33103010000

Furnace hot surface igniter kit. The igniter gets very hot and glows bright orange to light the gas burner. If the igniter is cracked or defective, the furnace won’t heat.

OEM Part - Manufacturer #S1-02532625000

Cap,run single,7.5mfd,370v,oval

OEM Part - Manufacturer #S1-02420045700

Condenser fan motor 1/4hp 230v 850rpm 1ph

OEM Part - Manufacturer #S1-02436237000

Door clip

OEM Part - Manufacturer #S1-02131399000

Contactor with shunt, 1 pole, 30 amps, 24 volts

OEM Part - Manufacturer #S1-02427531000

2.8 oz Tube of Red Devil High Temp RTV Silicone. Perfect for Gasket replacement. Not for Heat Exchangers.

Manufacturer #93247

Apply a small beed around inducer housings, flanges or anywhere metal touches metal, or where a gasket is normaly used.

Gas Burner Tube

OEM Part - Manufacturer #S1-02920482000

Flame rollout limit switch

OEM Part - Manufacturer #S1-02634027000

Flame sensor

OEM Part - Manufacturer #S1-02537499000

Furnace blower motor. This single-phase motor has the following specifications:

Horsepower: 1/6
Voltage: 115
Rated Amps: 7.8
Hertz: 60
RPM: 1000
Speeds: 1
Rotation: CCW
Frame: 42
Enclosure: Open

OEM Part - Manufacturer #S1-7966-311P

Triple-D Coil Cleaner is a 19oz Aerosol spray can, that is safe for homeowner use. One can will clean an entire outdoor condenser coil and/or indoor evaporator coil, to remove energy-stealing dirt, debris and soot.

Manufacturer #Triple-D-AER

TRIPLE-D™ is a triple active synergistic detergent system formulated to remove a broad range of soils with minimal time and effort. It will clean condensers, evaporators and Metal filters in HVAC-R systems. It contains NO toxic solvents and is nonflammable. Its unique system of surfactants, penetrants, and emulsifiers eliminates the need for expensive toxic solvent based degreasers. TRIPLE-D™ is biodegradable

Fan switch

OEM Part - Manufacturer #S1-7975-3281

Draft inducer blower assembly

OEM Part - Manufacturer #S1-02435329000

Pressure switch

OEM Part - Manufacturer #S1-02435271000

Upper limit switch, resettable

OEM Part - Manufacturer #S1-7624A3591

High Limit Themrostat

OEM Part - Manufacturer #S1-02529041002

Run capacitor, single,10mfd,370 volts, oval

OEM Part - Manufacturer #S1-02420046700

Pressure switch

OEM Part - Manufacturer #S1-02435261000

Inducer blower assembly

OEM Part - Manufacturer #S1-32647781000

Furnace fan/electric heat control board.

OEM Part - Manufacturer #S1-03101264002

Relay,fan,24v coil,50-60hz,spst-no/nc

OEM Part - Manufacturer #S1-S90-380

Flame sensor

OEM Part - Manufacturer #S1-02530788700

Flame rollout limit switch. 200'F open, manual close

OEM Part - Manufacturer #S1-02527792001

Dual Capacitor 45 + 5 MFD 370 volt

OEM Part - Manufacturer #S1-02425895700

Blower motor, 1/4 HP, 1075 RPM, 1 speed

OEM Part - Manufacturer #901874

1/4 hp 208-230volts 60hertz 1.4amps 1100rpm single

OEM Part - Manufacturer #S1-02436241000

Sensor rod

OEM Part - Manufacturer #S1-2702-311P

Flame rollout limit switch 320 degrees F open, manual reset

OEM Part - Manufacturer #S1-02527747016

Flame rollout limit switch, push button to re-set

OEM Part - Manufacturer #S1-02541318000

This thermostat has a manual reset

Pressure switch

OEM Part - Manufacturer #S1-02435286000

High Limit Thermostat

OEM Part - Manufacturer #S1-02529041004

Blower wheel, 11 x 10, cw, 1/2 bore

OEM Part - Manufacturer #S1-02619654014

Orifice,burner drill size 45

OEM Part - Manufacturer #S1-02921182245

Furnace blower motor. This single-phase motor has the following specifications:

Horsepower: 1/2
Voltage: 115
Full-Load Amperage: 10.7
Hertz: 60
RPM: 1110
Speeds: 3
Rotation: Counterclockwise
Frame: 48
Enclosure: Open
Shaft Length: 4.75”

OEM Part - Manufacturer #S1-02426003000

Limit Switch

OEM Part - Manufacturer #S1-02538737000

Universal Gas Valve, HSI/DSI Single Stage, Slow Opening, Inlet / Outlet Pressure Taps, Plastic Hose Barb (For Connection To ¼ Hose/Flexible Tubing), LP Gas Conversion Kit, Inlet/Outlet Reducer Bushings (1/2 NPT X 3/8 NPT) 100KBTU/Hr (Nat Gas), 24V, 60 Hz, 1/2 X 1/2 NPT, Replaces 36G24-214

Manufacturer #36J24-214

Blower motor, 1/3 HP, 115 volts, 60 hertz, 5.6 amps, 1075 RPM, 2 speed

OEM Part - Manufacturer #S1-02436266000

Flame rollout limit switch 185 degrees F open, manual reset

OEM Part - Manufacturer #S1-02530321700

Transformer 120v-pri 24v-sec 40va

OEM Part - Manufacturer #S1-2940A3541

Cap,run dual,30/5mfd,370v,round

OEM Part - Manufacturer #S1-02424778700

Door switch

OEM Part - Manufacturer #S1-02435738000

Furnace blower assembly with limit and gasket.

To prevent carbon monoxide from leaking into your home, we recommend replacing the draft inducer gasket when servicing the motor or inducer fan. If you do not have a gasket, you can use high-temperature silicone sealant to seal the furnace.

OEM Part - Manufacturer #S1-32434558000

If you do not have a gasket, you can use high-temperature silicone sealant to seal the furnace.

Run capacitor, Single, Oval, 370 Volts, 15 Microfarads

OEM Part - Manufacturer #S1-02425900000

Switch,pres,air,.40iwconfall,spno (text)

OEM Part - Manufacturer #S1-02435776000

Blade fuse. ATC-3 (3 Amp)

Manufacturer #ATC3

Pressure switch

OEM Part - Manufacturer #S1-02435272000

High Limit Thermostat

OEM Part - Manufacturer #S1-02529041005