Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.
Carrier furnace igniter. The igniter gets very hot and glows bright orange to light the gas burner. If the igniter is cracked or defective, the furnace won’t heat.
Contactor; 1p 40a 24vac / screw mount
Triple-D Coil Cleaner is a 19oz Aerosol spray can, that is safe for homeowner use. One can will clean an entire outdoor condenser coil and/or indoor evaporator coil, to remove energy-stealing dirt, debris and soot.
Time delay relay
Stainless steel burner
Dual run capacitor, 50+5 MFD, 370-440 volts
Capacitor, Start, 140*160 MFD, 330V, Round
Hot Surface Ignitor Kit
Thermal limit switch, open at 180 degrees, close at 150 degrees
Ignition Control Board
Fan capacitor, 440 volts, 5.0 MFD
Switch; switch-flame rollout, 82 degrees c, 180 deg
Dual run capacitor, round, 35/5 MFD, 440 volts