Furnace draft inducer assembly. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.
Flame rollout switch 300F resetable
Control fan timer
Blower vent 80+ 1-stg jakel kt
Triple-D Coil Cleaner is a 19oz Aerosol spray can, that is safe for homeowner use. One can will clean an entire outdoor condenser coil and/or indoor evaporator coil, to remove energy-stealing dirt, debris and soot.
Contactor 1 pole 25 amp 24 volt
Furnace burner igniter and flame sensor assembly. This is a 24 volt igniter.
Hot surface furnace igniter kit. <br>If the electrical connnector on your old part is different than the new igniter, it can be cut off and spliced onto the new igniter wires using the provided wire nuts.
3 Blade fan, 18" diameter 28 degree 1/2" CW
Switch vent press 90+ single port
Condenser fan motor. This single-phase motor has the following specifications: <br><br>Horsepower: 1/5<br> Voltage: 208-230<br> Full-Load Amperage: 1.3<br> Hertz: 60<br> RPM: 1075<br> Rotation: counterclockwise<br> Frame: 48<br> Enclosure: Closed<br> Shaft Length: 2.5”<br>
Single run capacitor, oval, 370 volts, 10 microfarads
Tube silicone 24" x 1/4"id
Condensate Pump. <br> Features:<br>* 16 foot lift<br>* Whisper quiet<br>* ½ Gallon Reservoir<br>* Rubber isolation feet<br>* 3/8" Check Valve
Door Retaining Screw