Furnace draft inducer assembly. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.
Flame rollout switch 300F resetable
Control fan timer
Left or right window curtain (must order two for the pair)
Contactor 1 pole 25 amp 24 volt
Condenser fan blade with slinnger ring
Blower vent 80+ 1-stg jakel kt
Triple-D Coil Cleaner is a 19oz Aerosol spray can, that is safe for homeowner use. One can will clean an entire outdoor condenser coil and/or indoor evaporator coil, to remove energy-stealing dirt, debris and soot.
Hot surface furnace igniter kit.
If the electrical connnector on your old part is different than the new igniter, it can be cut off and spliced onto the new igniter wires using the provided wire nuts.
Furnace burner igniter and flame sensor assembly. This is a 24 volt igniter.
3 Blade fan, 18" diameter 28 degree 1/2" CW
Condenser fan motor. This single-phase motor has the following specifications:
Full-Load Amperage: 1.3
Shaft Length: 2.5”
1/6 HP 208/230Volts 60Hertz 0.99Amps 1100RPM Single Speed Closed Enclosure 42Y Frame Single Phase Reversible Rotation 1.75" Shaft