Dryer drum slide. There are two of these needed on your dryer. These go on the inner most slots on the front bearing. Sold individually will need to purchase two*. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.
Dryer drum slide. There are two of these needed on your dryer. The dryer's drum slides help to support the front of the drum as it rotates. If the drum slides are worn out, the dryer will be noisy. Because the slides wear out at the same rate, we recommend replacing all of the slides together.
Dryer drum drive belt, 89-1/2 inches long, 4 ribs. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.
Dryer timer knob, white.
Oven igniter assembly. Short ceramic style igniter with mounting bracket and wire nuts for installation. Amperage range is 3.3 to 3.6. *Connector may need to be cut off and wires spliced to range wiring with porcelain wire nuts.
Dryer upper drum bearing without slides. If the dryer is noisy or squeaking then the slides are likely worn and both slides and this bearing will need to be replaced.
Evaporator fan motor assembly with wire harness
Oven bake or broil igniter, 2.5 to 3.0 Amp. The igniter draws electrical current through the oven safety valve to open it. If the igniter glows for more than 90 seconds without igniting the gas flame, this indicates that the igniter is too weak to open the valve. (NOTE: This part is very fragile.)
Washer tub dampening strap. If the washing machine tub is off-balance, then one or more of these straps may have broken.
Oven bake heating element. Push-on wire terminals. Includes feet for sitting on bottom of oven floor, and mounting plate for attaching to back wall of oven. Often, if the heating element has burned out, it will be visibly damaged. Inspect the heating element for holes or blisters.
Refrigerator or freezer temperature sensor (also called a thermistor). The thermistor monitors the refrigerator, freezer, and evaporator temperature and sends the temperature reading to the control board.
Burner drip bowl (also called a drip pan) for 6-inch burner. The drip pan sits underneath the heating element to collect drips or spills around the burner.
Refrigerator water inlet valve assembly with quick connect fitting . To disconnect the tube, push the white retainer fitting in while pulling on the tube. If the cold water is not coming out of the water dispenser, or if the ice maker won't dispense ice, the water inlet valve may be at fault.
GE MWF water filter reduces up to 94% of contaminants including lead, chlorine, and asbestos. Replace every 6 months. <br> <br> If you have never installed this new style filter or your old filter was made by Culligan you may need the adapter to install it, see Related Items below.
Dryer drum seal for the lower front.