Whirlpool Dryer CE1750XYN0 Parts

Dryer idler pulley assembly. Includes bracket and pulley wheel

Dryer drum drive belt, 93 1/2 inches long, 4 ribs 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

The drum support roller kit, 349241T. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

Dryer drum drive motor with pulley

Dryer idler pulley wheel kit. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin

Dryer high limit thermostat and thermal fuse kit. If the dryer does not heat the most common cause is a blown thermal fuse. Both the thermostat and fuse can be tested to determine if either is defective.352 F fuse. L146.1-44.4c thermostat.

Plastic leveling leg. White approximately 1" round x 1 3/4" long

Dryer door catch kit

The Whirlpool Blower Wheel WP697772 is a high-quality replacement part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. It is important to use safety equipment and disconnect the appliance before any service or repair.

Dryer tri-ring retainer for drum support rollers.

Motor pulley, 60 hertz

Dryer drum felt seal kit. Includes silicone rubber adhesive.

White Touch Up Paint

Dryer thermal fuse (or thermal limiter). This fuse is located on the exhaust duct. If the dryer overheats, the thermal fuse opens to cut off power to the dryer. The thermal fuse cannot be reset--if the thermal fuse is open, it must be replaced.

Screw, 10-24 x 1/2