Dryer thermal fuse located on the blower housing. If the dryer overheats, the thermal fuse blows cutting off power to the motor or the heating system. When the fuse is bad the dryer won't start or will run but not heat. The thermal fuse cannot be reset. Fuses often blow due to a clogged dryer vent.
Microwave incandescent light bulb, 40 Watt. Comes with small screw in base. If the light bulb threads are corroded, or the bulb base is too large, the socket may also need to be replaced.
Lower dishrack roller assembly, gray, (4) required to replace them all. Sold individually
FreshFlow air filter, reduces common food odors in the refrigerator. 15 times more powerful than baking soda. Replace every 6 months.
Dishrack adjuster arm. Fits both left and right side. Allows the upper rack to be raised and lowered to accomadate different size dishes.
Dishwasher upper rack adjuster kit. This kit includes both left and right side adjusters and all components needed to service the upper rack. The part has changed from plastic to metal. So it will look different than the original part. Instructions available online at Servicematters.com.
Dryer drum drive belt. The belt is flat, 92-1/4 inches long, 1/4 inch wide and has 4 ribs and 3 grooves. It replaces many other belts, including some with 5 ribs and 4 grooves. If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.
Lower dishrack roller assembly, gray, sold individually you will need (4) roller assemblys to replace them all.
Dryer heating element. If your dryer does not heat first check for a blown thermal fuse on the blower housing before replacing the heating element. In most cases the heating element will have a break in the element if defective. *May need wire connector to install heating element.
40 Watt frosted appliance light bulb.
EveryDrop Ice & Water Refrigerator Filter 1, two port filter, reduces 24 contaminants, including lead, asbestos, and industrial chemicals. Each filter provides 200 gallons of filtered water and should be changed every 6 months to ensure proper contaminant removal and flow rate. NSF certified.
Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.
Grease filter assembly 13" X 6"
Charcoal filter. Measures approximately 5 1/2" x 5"
Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.