Shop replacement repair parts for Carrier Furnace model 58SSB080-121BC

Single run capacitor 440V 7.5 mfd

Gas burner tube

Furnace draft inducer motor with cooling fan. Be aware that the screw holes are not threaded—you will need to use self-tapping screws to install the motor.

Furnace draft inducer motor cooling fan blade and clip. You may have to cut the old clip off to remove the fan blade.

Blower wheel for draft inducer motor 4" Diameter 1.5" Width

Transformer, 120V-24V 40VA

Clip

Grommet, motor mounting bracket. Sold as a single grommet but we suggest purchasing three since there are 3 holding the motor in place, and it’s a good practice to change all of them while the assembly is taken apart.

High limit thermostat, 180 degrees Fahrenheit

Blower wheel 11 1/8"d x 7 1/8"

High efficiency furnace control board. The control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Fuse

.43 MM orifice, pack of 7. *Should be installed by a certified Carrier repairperson.

Fuse Link Kit

Pressure switch