Shop replacement repair parts for Lennox Furnace model F8AUH-100-1

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Capacitor single run 7.5 MFD 370 Volt oval

Transformer

Flame rollout limit switch - manual reset

1/2HP 115Volts 60Hz 8 amp 1075 RPM's 5 Speed Open Enclosure 48Y Frame Single Phase CCW 3" Shaft. Any unused wires will need to be taped off or put on the "park" terminals on the control board. These terminals are there specifically for unused wires.

Blower motor, 3/4 HP, 115 Volts, 60 Hz, 10 amps, 1075 RPM's, 5 speed open enclosure, 48Y, Frame Single Phase CCW, 2.75" shaft

Limit Switch

Gasket

Blower-ind draft

Lead




Blade fuse, 32v, 3a, 10 pack

Bracket