Shop replacement repair parts for Lennox Furnace model G23Q4-125-5

Furnace Igniter (80 volt) *** please see related item if 120 volt igniter is needed***

Capacitor single run 7.5 MFD 370 Volt oval

White-Rodgers 21D83M-843 Direct Replacement IFC Ignition Module The ignitiov control moduleregulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Flame sensor kit. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Switch-interlock

Transformer, 120 Volt Primary 24 Volt Secondary 40 VA

Blower wheel, 10 5/8 length 10 5/8 diameter, 1/2 inch bore

1/2HP 115Volts 60Hz 8 amp 1075 RPM's 5 Speed Open Enclosure 48Y Frame Single Phase CCW 3" Shaft. Any unused wires will need to be taped off or put on the "park" terminals on the control board. These terminals are there specifically for unused wires.

Main burner

Flame sensor wire lead

Circuit Breaker Switch

Furnace draft inducer motor. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Gasket


Bracket