Price Match GuaranteeLennox Furnace G26Q3-125-3 Parts
Shop replacement repair parts for Lennox Furnace model G26Q3-125-3
Furnace Igniter (80 volt) *** please see related item if 120 volt igniter is needed***
Capacitor single run 7.5 MFD 370 Volt oval
White-Rodgers 21D83M-843 Direct Replacement IFC Ignition Module The ignitiov control moduleregulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.
Flame sensor kit. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.
Switch-interlock
Pressure switch
Transformer, 120 Volt Primary 24 Volt Secondary 40 VA
Blower wheel, 10 5/8 length 10 5/8 diameter, 1/2 inch bore
1/2HP 115Volts 60Hz 8 amp 1075 RPM's 5 Speed Open Enclosure 48Y Frame Single Phase CCW 3" Shaft. Any unused wires will need to be taped off or put on the "park" terminals on the control board. These terminals are there specifically for unused wires.
Fitting
Roll out manual reset limit safety switch
Main burner
Circuit Breaker Switch
Boot
Flue transition replacement kit
Frequently Purchased Together For This Model
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic