Price Match GuaranteeLennox Furnace G40DF-48C-110-11 Parts
Shop replacement repair parts for Lennox Furnace model G40DF-48C-110-11
Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.
Furnace igniter assembly
Capacitor single run 7.5 MFD 370 Volt oval
Switch-interlock
Blower wheel, 10 5/8 length 10 5/8 diameter, 1/2 inch bore
Furnace draft inducer motor.115Volts 60Hz 1.2 amp 3000 RPM's Closed Enclosure. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.
1/2HP 115Volts 60Hz 8 amp 1075 RPM's 5 Speed Open Enclosure 48Y Frame Single Phase CCW 3" Shaft. Any unused wires will need to be taped off or put on the "park" terminals on the control board. These terminals are there specifically for unused wires.
Gasket
Main burner
Pressure switch
Limit Switch
Limit control, rollout, 210f
Limit control, 135 f
Gas valve conversion kit, natural to LP. *Should be installed by a certified Carrier repairperson.
Pressure switch tubing kit
Frequently Purchased Together For This Model
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic