Shop replacement repair parts for York Furnace model P2DRB12N05501A

Furnace control board. The control board regulates the supply of power to the furnace components.

Gas Burner Tube

Furnace hot surface igniter kit. The igniter gets very hot and glows bright orange to light the gas burner. If the igniter is cracked or defective, the furnace won’t heat.

Genteq Run Capacitor 370 Volt Oval Single 7.5 MFD

Furnace blower motor. This single-phase motor has the following specifications:
Horsepower: 1/2
Voltage: 115
Full-Load Amperage: 7.7
Hertz: 60
RPM: 1175
Speeds: 4
Rotation: Counterclockwise
Frame: 48
Enclosure: Open

Gas valve kit

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Orifice,burner drill size 45

Pressure switch

Transformer, 120 volt primary 24 volt secondary 40 va

Limit switch,160 open,130 close

Furnace draft inducer motor. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Pressure Switch, -0.75 SPNO contacts close on fall

Natural gas to LP conversion kit. *Should be installed by a certified York repairperson.

Air pressure switch