Shop replacement repair parts for York Furnace model LY8S060A12UH11A

Furnace control board. The control board regulates the supply of power to the furnace components.

Gas Burner Tube

Furnace hot surface igniter kit. The igniter gets very hot and glows bright orange to light the gas burner. If the igniter is cracked or defective, the furnace won’t heat.

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Genteq Run Capacitor 370 Volt Oval Single 7.5 MFD

Draft inducer blower assembly. 60 Hz 1.75 Amps, 3000 RPM.The draft inducer blower draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Pressure switch -.5" WC SPNO

Blade fuse. ATC-3 (3 Amp)

Pressure switch tubing .313 OD .188 ID

Gas valve kit

Orifice,burner drill size 45

Furnace blower motor. This single-phase motor has the following specifications:
Horsepower: 1/3
Voltage: 115
Full-Load Amperage: 6.2
Hertz: 60
RPM: 1075
Speeds: 4
Rotation: Counterclockwise LE
Frame: 48
Enclosure: Open
Shaft Length: 4”

Limit themrostat switch

Flame rollout limit switch 185 degrees F open, manual reset

Transformer, 120 volt primary 24 volt secondary 40 va