Shop replacement repair parts for York Furnace model TGLS080B12MP11


Furnace control board. The control board regulates the supply of power to the furnace components.

Gas Burner Tube

Furnace hot surface igniter kit. The igniter gets very hot and glows bright orange to light the gas burner. If the igniter is cracked or defective, the furnace won’t heat.

Limit thermostat, 150 open, 110 close

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Flame rollout limit switch, push button to re-set

Pressure switch tubing .313 OD .188 ID

Door switch

Gas valve kit

Air pressure switch

Orifice,burner drill size 45

Combustion blower, 800-100 BTU. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Furnace blower motor. This single-phase motor has the following specifications:
Horsepower: 1/3
Voltage: 115
Full-Load Amperage: 6.2
Hertz: 60
RPM: 1075
Speeds: 4
Rotation: Counterclockwise LE
Frame: 48
Enclosure: Open
Shaft Length: 4”

Transformer 120v-pri 24v-sec 40va

Blower motor mounting kit