LG Dryer DLGY1702W Parts

Drum Support Roller & Axle Set of 4 AGM75510755 set includes 4 drum rollers, the roller shaft, and mounting clips to ensure quiet operation. As the bearings wear, they self-lubricate, eliminating the need for additional grease. This set is compatible with various dryer models from LG and Kenmore.

Dryer drum drive belt. 1/4 inch wide with 4 ribs and 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Thermostat and thermistor kit. The thermostat has reset button in center that will trip due to poor air flow such as a clogged exhaust vent.

Dryer moisture sensor bar. If the dryer timer does not advance properly inspect the moisture sensor bars for damage which can cause the automatic drying cycle to not work properly.

Dryer idler pulley and spring kit for drum drive belt

High limit thermostat at blower housing

Gas dryer igniter with bracket and wire harness. This is a round spiral-style igniter. The igniter uses heat to ignite the gas in the burner assembly. If the igniter is defective, the gas will not ignite and the dryer will not heat.

Guide cover

Felt seal, dryer drum

Dryer gas burner valve assembly. Two solenoids. When installing the new valve, transfer the orifice from the old valve to the new valve.

Idler pulley wheel with bearing

Blower wheel

Switch assembly, safety

Dryer drum drive motor with pulley. If the dryer does not start the motor could be bad. Before replacing the motor the door switch and thermal fuse should be tested to determine if they are defective.

Gas dryer flame sensor