GE Dryer DDC4500SFM Parts

Dryer drum slide. There are two of these needed on your dryer. These go on the outer most slots on the front bearing. Sold as pack of two. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.

Dryer drum slide (2 pack). There are two of these needed on your dryer. These go on the inner most slots on the front bearing. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.

Dryer idler pulley wheel. If the pulley wheel is worn down, it may cause the dryer to be excessively noisy.

The GE Appliances Drum Bearing Kit WE25M40 is a high quality, Genuine OEM part that supports the rear of the dryer drum, ensuring smooth and quiet rotation. It is important to disconnect all utilities before installation.

Gas dryer igniter assembly with bracket and wire harness. If the dryer does not heat then the igniter may have burned out. The burned spot is normally visible. Be aware the igniter is very fragile.

Dryer drive belt. This is the most common GE/Hotpoint dryer belt. 87" long and 1/4" wide. 4 ridges.The drive belt dries out over time. If the dryer belt cracks or breaks, the dryer drum will not be able to turn. If the dryer motor is running, but the drum won't rotate, the belt has likely broken.

Door switch

High-limit thermostat for dryer. L315-65. If the dryer overheats, this high-limit thermostat will cut off the power to the drive motor. If the high-limit thermostat has blown, the dryer won't start.

All purpose switch

Door handle, white. Snaps in place

Dryer gas valve solenoid coil. Has two terminals.

Gas valve solenoid coil 3 terminal

Thermostat, high limit

Screw #10

Dryer motor kit. Replaces old "T" & "V" style motors. Includes 2 motor pulleys and basic directions. Common symptoms of a bad drive motor are:
-Dryer stops turning during cycle
-Dryer won't start
-Dryer won't turn at al