Shop replacement repair parts for GE Dryer model DPSF505GW1AA

If your clothes dryer drum doesn't turn when the dryer is on, you likely need the Drive Belt WE03X29897, which is 89-1/2 inches long with four ribs. This genuine OEM replacement part is compatible with Whirlpool, Kenmore, GE, Hotpoint, and RCA dryers and washer/dryer combos.

Dryer drum slide. There are two of these needed on your dryer. These go on the outer most slots on the front bearing. Sold as pack of two. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.

Dryer drum slide (2 pack). There are two of these needed on your dryer. These go on the inner most slots on the front bearing. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.

Dryer drum seal for the lower front. If the seal is worn the drum glides are likely worn and may need to be replaced. See related items below.

Dryer idler pulley wheel. If the pulley wheel is worn down, it may cause the dryer to be excessively noisy.

Light bulb, 120V, 10W

The GE Appliances Drum Bearing Kit WE25M40 is a high quality, Genuine OEM part that supports the rear of the dryer drum, ensuring smooth and quiet rotation. It is important to disconnect all utilities before installation.

Front bulkhead assembly with moisture sensor bars.

Gas dryer igniter assembly with bracket and wire harness. If the dryer does not heat then the igniter may have burned out. The burned spot is normally visible. Be aware the igniter is very fragile.

Dryer lint filter. Keeping the filter clean is vital to dryer operation.

Door switch

All purpose switch

Dryer timer knob assembly in white with chrome accent ring and black indicator. The knob has a D shaped shaft and is 2-3/4 inches in diameter.

Door handle, white. Snaps in place

Dryer gas valve solenoid coil. Has two terminals.