Whirlpool Dryer GEW9878JQ0 Parts

Dryer drum drive belt. This belt is approximately 1/4" wide x 92-1/4" long. It is flat on one side and has 4 ribs and 3 grooves on the other. It replaces many other belts, including some with 5 ribs and 4 grooves. The belt attaches to the motor pulley and spins the drum as the motor rotates

Dryer door switch assembly. If the dryer does not start then the door switch could be defective. This switch also replaces the two wire switch.

The drum support roller kit, 349241T. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.

Dryer drum drive motor with pulley

Idler pulley for dryer drum drive belt

Dryer blower wheel. Used on 29 inch Whirlpool built models with lint filter on top. To remove the blower wheel, unscrew the blower wheel clockwise off the motor shaft.

Whirlpool's replacement thermostat kit includes a thermal cut-off fuse, high-limit thermostat, and electrical connection hardware to ensure your clothes are perfectly dry. Keep up with laundry by installing this genuine Whirlpool replacement part.

Plastic leveling leg. White approximately 1" round x 1 3/4" long

Dryer door catch kit

Dryer drum rear felt seal kit with adhesive.

Dryer tri-ring retainer for drum support rollers.

Dryer heating element wire connector kit. Wire with spade terminal & wire nut

This is a genuine replacement part. Whirlpool 349639 Lint Screen.

Motor pulley, 60 hertz