GE Dryer DNXR473GW3AA Parts

If your clothes dryer drum doesn't turn when the dryer is on, you likely need the Drive Belt WE03X29897, which is 89-1/2 inches long with four ribs. This genuine OEM replacement part is compatible with Whirlpool, Kenmore, GE, Hotpoint, and RCA dryers and washer/dryer combos.

Dryer drum slide. There are two of these needed on your dryer. These go on the outer most slots on the front bearing. Sold as pack of two. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.

Dryer drum seal for the lower front. If the seal is worn the drum glides are likely worn and may need to be replaced. See related items below.

Dryer idler pulley wheel. If the pulley wheel is worn down, it may cause the dryer to be excessively noisy.

The GE Appliances Drum Bearing Kit WE25M40 is a high quality, Genuine OEM part that supports the rear of the dryer drum, ensuring smooth and quiet rotation. It is important to disconnect all utilities before installation.

Gas dryer igniter assembly with bracket and wire harness. If the dryer does not heat then the igniter may have burned out. The burned spot is normally visible. Be aware the igniter is very fragile.

Front bulkhead assembly with moisture sensor bars.

Door switch

All purpose switch

The Genuine OEM GE Appliances Cycling Thermostat regulates the internal temperature of the dryer and has limits of 210°F to 30°F. It is recommended to disconnect the appliance from all utilities prior to installation. Compatible with various GE models.

Dryer gas valve solenoid coil. Has two terminals.

Gas valve solenoid coil 3 terminal

Door handle, white. Snaps in place

Thermostat, high limit

Screw #10