Montgomery Wards Dryer LNC8435A/REVC Parts

Dryer drum drive belt. This belt is approximately 1/4" wide x 92-1/4" long. It is flat on one side and has 4 ribs and 3 grooves on the other. It replaces many other belts, including some with 5 ribs and 4 grooves. The belt attaches to the motor pulley and spins the drum as the motor rotates

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Dryer gas valve solenoid coil kit. The kit includes both 2 and 3 wire coils. If the dryer does not heat or heats intermittently the gas valve coils may be defective.

Dryer thermal fuse and high limit thermostat kit for both gas and electric models. If the dryer does not heat then the thermal fuse may have blown and will need to be replaced.

Door catch kit, includes catch and clip (metal) Replace both parts for best results

Drum glide kit, right side. *Pad has adhesive backing

The Whirlpool Burner Igniter WP31001556 is a high-quality replacement part for dryers that lights the gas burner to heat the dryer during the cycle. It replaces several other part numbers. Disconnect the appliance from all utilities prior to installation.

Front glide kit, (1) right (1) left glide (2) pads with adhesive backing. Instructions included.

Lint screen housing duct kit

Leveling Leg

Gas valve conversion kit, Natural to LP (liquid propane) gas.

Cycling thermostat, L146-25, 2 wire with extra terminal

Glide for main drum front support, left side

Glide for main drum front support, right side

Motor swit