White-Westinghouse Washer/Dryer Combo WLXG42REW4 Parts

Dryer drum belt, length 88.75" x width 1/4". If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.

Dryer rear drum bearing kit. The holes in the metal plate are not threaded. Use the self tapping screws in the kit to thread the plate. If the dryer is noisy then the rear bearing could be worn and require replacement.

Dryer drum glide. These drum glides help to support the front of the dryer drum as it rotates. Sold individually. It is recommended to replace both at one time.

Dryer lint trap. Proper air flow is critical to dryer operation so the filter should be cleaned before every load. Replace the filter if it has any tears or rips in it.

Washer drive belt. If this belt is broken, the washer will not spin or agitate.

Dryer gas valve solenoid coil kit. The kit includes both 2 and 3 wire coils. If the dryer does not heat or heats intermittently the gas valve coils may be defective.

Washing machine drain pump. On some models you will need to configure the replacement pump to match the old pumps outlet port direction and reuse the old mounting bracket. If the washer does not drain then the drain pump may be clogged, damaged, or defective.

Bearing cup for drum support ball

Lower felt for drum seal

Idler pulley and arm, dryer

The Frigidaire Blower Wheel 131476300 is a high-quality part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. Recommended to use safety equipment. Disconnect the appliance before repair. Consult the owner's manual for instructions.

Upper seal for drum seal

Drive Motor for Dryer Drum and Blower With Pulley

This is a Genuine Replacement Part. Frigidaire (ELEHI) 131789400 Door Handle.

Leveling leg