Whirlpool Dryer 3RAWZ481EML2 Parts

Dryer thermal fuse. Opens at approximately 196°F (91°C). *If open check for air flow issues like plugged exhaust vent or damaged blower wheel

Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

Dryer idler pulley assembly. Includes bracket and pulley wheel

Dryer drum drive belt, 93 1/2 inches long, 4 ribs 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Dryer idler pulley wheel kit. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin

Dryer lint filter. Air flow is vital to proper dryer operation. The lint filter should be cleaned before every load and replaced if damaged.

Plastic leveling leg. White approximately 1" round x 1 3/4" long

Dryer door catch kit

The Whirlpool Blower Wheel WP697772 is a high-quality replacement part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. It is important to use safety equipment and disconnect the appliance before any service or repair.

Dryer tri-ring retainer for drum support rollers.

Dryer heating element wire connector kit. Wire with spade terminal & wire nut

Dryer drum felt seal kit. Includes silicone rubber adhesive.

Heating element thermal cut-off (thermal fuse) 360 degrees and high-limit thermostat 250 degrees. The thermal fuse is a safety device designed to protect the dryer from overheating. A multimeter can be used to test the fuse. Always check the dryer venting when replacing a blown thermal fuse.

Outer grille

Screw, 10-24 x 1/2