Price Match GuaranteeWhirlpool Dryer WGD6400SW1 Parts
Shop replacement repair parts for Whirlpool Dryer model WGD6400SW1
Dryer thermal fuse. Opens at approximately 196°F (91°C). *If open check for air flow issues like plugged exhaust vent or damaged blower wheel
Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.
Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.
Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.
The Whirlpool Burner Igniter Kit 279311 is a high-quality replacement part that ignites gas to light the dryer burner. It replaces multiple igniters and requires safety precautions and disconnection from utilities before installation.
High-limit thermostat kit. Contains hi limit thermostat and thermal cut out fuse. If the dryer overheats, the high-limit thermostat cuts off power to the dryer. If the dryer won't heat, the high-limit thermostat may have blown. This part has been updated by the manufacturer and may look different.
Dryer blower wheel. Used on 29 inch Whirlpool built models with lint filter on top. To remove the blower wheel, unscrew the blower wheel clockwise off the motor shaft.
Plastic leveling leg. White approximately 1" round x 1 3/4" long
Dryer tri-ring retainer for drum support rollers.
Motor pulley, 60 hertz
Light Bulb 10 Watt small base
Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.
Dryer door catch. If the dryer door does not latch closed then the door strike or this catch is likely damaged
White Touch Up Paint
Dryer blower housing foam seal with adhesive backing. 26 in
Frequently Purchased Together For This Model
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic