GE Dryer DCVH660EH3MS Parts

If your clothes dryer drum doesn't turn when the dryer is on, you likely need the Drive Belt WE03X29897, which is 89-1/2 inches long with four ribs. This genuine OEM replacement part is compatible with Whirlpool, Kenmore, GE, Hotpoint, and RCA dryers and washer/dryer combos.

Dryer drum slide. There are two of these needed on your dryer. These go on the outer most slots on the front bearing. Sold as pack of two. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.

Dryer drum slide (2 pack). There are two of these needed on your dryer. These go on the inner most slots on the front bearing. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.

Rear drum bearing sleeve

Dryer drum seal for the lower front. If the seal is worn the drum glides are likely worn and may need to be replaced. See related items below.

Dryer idler pulley wheel. If the pulley wheel is worn down, it may cause the dryer to be excessively noisy.

Light bulb, 120V, 10W

The GE Appliances Drum Bearing Kit WE25M40 is a high quality, Genuine OEM part that supports the rear of the dryer drum, ensuring smooth and quiet rotation. It is important to disconnect all utilities before installation.

Mica heater unit

Door switch

High-limit thermostat for dryer. L315-65. If the dryer overheats, this high-limit thermostat will cut off the power to the drive motor. If the high-limit thermostat has blown, the dryer won't start.

All purpose switch

Inlet control thermistor. Resistence reading should be around 100K ohms at room temperature and decrease with temperature rise.

6 Foot 30 Amp 3 wire dryer cord

Screw #10