Price Match GuaranteeGE Dryer DNCK440GG7WC Parts
Shop replacement repair parts for GE Dryer model DNCK440GG7WC
If your clothes dryer drum doesn't turn when the dryer is on, you likely need the Drive Belt WE03X29897, which is 89-1/2 inches long with four ribs. This genuine OEM replacement part is compatible with Whirlpool, Kenmore, GE, Hotpoint, and RCA dryers and washer/dryer combos.
Dryer drum slide. There are two of these needed on your dryer. These go on the outer most slots on the front bearing. Sold as pack of two. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.
Dryer drum slide (2 pack). There are two of these needed on your dryer. These go on the inner most slots on the front bearing. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.
The GE Appliances Front Drum Support Bearing WE3M26 is a high-quality part that allows the front of the drum to glide smoothly on the felt seal of the front panel when the drum is rotating. It is also called the Drum Glide Bearing. Disconnect the appliance from all utilities prior to installation.
Rear drum bearing sleeve
Dryer drum seal for the lower front. If the seal is worn the drum glides are likely worn and may need to be replaced. See related items below.
Dryer idler pulley wheel. If the pulley wheel is worn down, it may cause the dryer to be excessively noisy.
The GE Appliances Drum Bearing Kit WE25M40 is a high quality, Genuine OEM part that supports the rear of the dryer drum, ensuring smooth and quiet rotation. It is important to disconnect all utilities before installation.
RC Item #4467076
Front bulkhead assembly with moisture sensor bars.
Gas dryer igniter assembly with bracket and wire harness. If the dryer does not heat then the igniter may have burned out. The burned spot is normally visible. Be aware the igniter is very fragile.
Dryer lint filter. Keeping the filter clean is vital to dryer operation.
Door switch
High-limit thermostat for dryer. L315-65. If the dryer overheats, this high-limit thermostat will cut off the power to the drive motor. If the high-limit thermostat has blown, the dryer won't start.
The Genuine OEM GE Appliances Cycling Thermostat regulates the internal temperature of the dryer and has limits of 210°F to 30°F. It is recommended to disconnect the appliance from all utilities prior to installation. Compatible with various GE models.
All purpose switch
Frequently Purchased Together For This Model
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic