Dryer drum drive belt. The belt is flat, 92-1/4 inches long, 1/4 inch wide and has 4 ribs and 3 grooves. It replaces many other belts, including some with 5 ribs and 4 grooves. If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.
Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.
Snap retaining ring. Used to keep rollers and idler wheels in place
Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.
Dryer thermal fuse and high limit thermostat kit for both gas and electric models. If the dryer does not heat then the thermal fuse may have blown and will need to be replaced.
Dryer lint filter (lint trap). Your lint filter should be replaced if it is torn or damaged in any way.
Screw, 10-24 3/8
Door catch kit, includes catch and clip (metal) Replace both parts for best results
Glow bar igniter with wire harness
Screw & Washer
Drum glide kit, right side. *Pad has adhesive backing
Blower wheel clamp
8-32 X .750 HW LR SG