Maytag Packaged Unit/RTU Parts

Run capacitor, round 440 volt 45/5 uf

Furnace flame sensor with wire harness

Contactor, 2 pole, 30 amp, 24 vac **Special Note** This may replace single pole contactor and require a technican to install (based on model #)

Limit switch, manual reset

Contactor 1 pole, 25fla, 24v

.43 Natural gas burner orifice

300f m/r rollout limit switch

Run Capacitor, Single, Round, 370 Volts 10 Microfarads

Limit Switch

Inshot burner tube

Two pole switch, 190F

Run capacitor, round, 7.5 MFD, 370 volts

Pressure switch, -0.55"wc

Primary auto limit switch

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.