Price Match GuaranteeSamsung Dryer DV42H5200EF/A3-0000 Parts
Shop replacement repair parts for Samsung Dryer model DV42H5200EF/A3-0000
Dryer Heating element. If the dryer does not heat check for a blown thermal fuse or thermal cut out. Heating elements will often have a break in the coil element if defective.
Dryer drum roller assembly. Includes the roller shaft and mounting clips. As the bearing in the roller wears, it self-lubricates so no grease is needed. If the dryer is noisy then one or more of the rollers may be worn. The rollers should be replaced in sets either both front or both rear.
Dryer drum drive belt. This slender belt wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.
Idler pulley and bracket for dryer drum belt
Dryer thermal fuse (also called the thermal limit). Located on the blower housing. The thermal fuse blows to cut off power to the dryer if the dryer overheats. If the thermal fuse has blown, the dryer won't start. The thermal fuse cannot be reset--if the fuse has blown, it must be replaced.
Dryer thermistor. If the dryer displays a fault code the thermistor may be defective.
Dryer heating element assembly. If the dryer no longer heats then the heating element may have failed, but it is not the most common cause. The most common cause for a dryer to stop heating is a blown thermal fuse.
Thermal fuse with bracket, located on the element housing. The fuse is not resettable and will need to be replaced if blown. If the dryer does not heat, the thermal fuse may be blown.
Dryer moisture sensor. The moisture sensor monitors the clothing’s moisture level and sends a signal to the control board when the clothes are dry. If your dryer turns off too early or continues running for a while after the clothes are dry, the moisture sensor might be damaged.
Dryer drum drive motor & blower housing assembly
Door switch
Dryer thermal fuse on heater housing (non-resettable). The original thermo-protector is riveted to the mounting bracket. You will need to drill out the rivets and replace the new high limit with self-tapping screws. Item # 2074129 comes with the fuse limit already attached to the bracket.
RC Item #2068552
Gas dryer igniter, Samsung
Idler pulley spring
Filter case
Frequently Purchased Together For This Model
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic