Shop replacement repair parts for Kenmore Dryer model 11086294510

Dryer drum drive belt. This belt is approximately 1/4" wide x 92-1/4" long. It is flat on one side and has 4 ribs and 3 grooves on the other. It replaces many other belts, including some with 5 ribs and 4 grooves. The belt attaches to the motor pulley and spins the drum as the motor rotates

The drum support roller kit, 349241T. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

Light Bulb, 40 Watts regular base

Dryer blower wheel. Used on 29 inch Whirlpool built models with lint filter on top. To remove the blower wheel, unscrew the blower wheel clockwise off the motor shaft.

Dryer door catch kit

Dryer heating element wire connector kit. Wire with spade terminal & wire nut

This is a genuine replacement part. Whirlpool 349639 Lint Screen.

Dryer thermal fuse (or thermal limiter). This fuse is located on the exhaust duct. If the dryer overheats, the thermal fuse opens to cut off power to the dryer. The thermal fuse cannot be reset--if the thermal fuse is open, it must be replaced.

Screw, 10-24 x 1/2

Ring bearing kit, front of dryer drum

Door seal

Shaft for drum support roller, left side

Heating Element for dryer Whirlpool/Kenmore part #WP4391960

Screw, 10-24 3/8

Front panel felt seal. No glue required, the seal stretches to fit. Note that seal no longer comes with the plastic retainers, reuse the old retainers.