Maytag Dryer MDG7057BWW Parts

Dryer drum support roller kit. Includes two washers. When the drum rollers are worn out, they can cause the dryer to make a loud rumbling noise. Both rollers should be replaced at the same time. The roller does not need lubrication, the bearing is self-lubricating.

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

The Whirlpool Dryer Cycling Thermostat WP3387134, rated at L155-25, regulates the temperature within your dryer. Signs that the thermostat needs replacement include inconsistent drying temperatures or the dryer running excessively hot. The WP3387134 is compatible with various dryer models.

Snap retaining ring

Dryer drum drive belt

Light Bulb 10 Watt small base

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Dryer drum bearing slide kit

Idler pulley wheel and bearing. If the idler pulley wheel and/or bearing is defective, it may cause the dryer to be excessively noisy.

Lint filter assembly

This is a genuine replacement part. Whirlpool 33001621 Knob Skirt.

Dryer igniter with wire harness connecter. This is a flat-style igniter. The igniter uses heat to ignite the gas in the burner assembly. If the igniter is defective, the gas will not ignite and the dryer will not heat.

Drum baffle, tall

Drum felt seal

Screw, 10-24 3/8