Price Match GuaranteeKenmore Dryer 110.72886100 Parts
Shop replacement repair parts for Kenmore Dryer model 110.72886100
Dryer drum drive belt. This belt is approximately 1/4" wide x 92-1/4" long. It is flat on one side and has 4 ribs and 3 grooves on the other. It replaces many other belts, including some with 5 ribs and 4 grooves. The belt attaches to the motor pulley and spins the drum as the motor rotates
The Dryer Repair & Maintenance Kit 4392065 includes rollers, a belt, and an idler pulley. It is specifically designed for 29 wide dryers built in 1965 or later. This kit addresses common issues that cause Whirlpool, Kenmore, Maytag, and KitchenAid dryers to become noisy.
The drum support roller kit, 349241T. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.
Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.
Idler pulley for dryer drum drive belt
Dryer drum drive motor with pulley
High-limit thermostat kit. Contains hi limit thermostat and thermal cut out fuse. If the dryer overheats, the high-limit thermostat cuts off power to the dryer. If the dryer won't heat, the high-limit thermostat may have blown. This part has been updated by the manufacturer and may look different.
Dryer blower wheel. Used on 29 inch Whirlpool built models with lint filter on top. To remove the blower wheel, unscrew the blower wheel clockwise off the motor shaft.
Dryer door catch kit
Dryer tri-ring retainer for drum support rollers.
Motor pulley, 60 hertz
Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.
White Touch Up Paint
Dryer thermal fuse (or thermal limiter). This fuse is located on the exhaust duct. If the dryer overheats, the thermal fuse opens to cut off power to the dryer. The thermal fuse cannot be reset--if the thermal fuse is open, it must be replaced.
Lint screen housing foam seal
Frequently Purchased Together For This Model
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic