Maytag Dryer MDE12PDBEW Parts

Dryer drum support roller kit. Includes two washers. When the drum rollers are worn out, they can cause the dryer to make a loud rumbling noise. Both rollers should be replaced at the same time. The roller does not need lubrication, the bearing is self-lubricating.

Dryer drum drive belt, 100 inches long, 3/8" wide,5 ribs 4 grooves. The drive belt wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Snap retaining ring

Dryer blower wheel for exhaust with clamp. If the dryer does not heat properly then this wheel may be stripped causing an air flow problem.

Dryer drum bearing slide kit

Dryer idley pulley. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin.

Screw, 10-24 3/8

Three terminal door switch kit. Be aware that this switch replaces older 2 terminal switches.

Dryer door latch & catch kit

Electric dryer power cord kit, 4 foot 30 Amp 3 wire w/closed eyelets & strain relief

Felt seal

Dryer drum drive motor. New style motor switch, The motor will need re-wiring.
Common symptoms of a bad drive motor are:
-Dryer stops turning during cycle
-Dryer won't start
-Dryer won't turn at all

Adjustable dryer cycling thermostat kit L135-155. The cycling thermostat cycles the heat on and off to regulate the air temperature. If the cycling thermostat is defective, the dryer will not heat. To determine if the thermostat is defective, use a multimeter to test it for continuity.

Door catch kit, includes catch and clip (metal) Replace both parts for best results

Spring clamp for blower wheel