Shop replacement repair parts for Bosch Dishwasher model SHX99A15UC/19

The Bosch Door Seal 00494772 is a genuine OEM part that seals the gap between the dishwasher tub and the outer edge of the door. It is compatible with various dishwasher models and can be installed without tools.

The Bosch Lower Door Seal 00432490 is a high-quality OEM part that seals the gap between the dishwasher door and tub. It includes mounting brackets and replaces several original part numbers. Safety precautions should be taken during installation. Compatible with various Bosch dishwasher models.

Cap shaped handle.

Dishwasher drain pump. If the water does not drain from the dishwasher then the drain pump may be clogged, damaged, or defective. *You may need to order the related wire connector to install.

The Bosch Water Inlet Valve 00425458 is a high quality OEM part that supplies water to the dishwasher. It has a single water in-flow and out-flow port and is compatible with various Bosch, Kenmore, and Thermador dishwasher models. Safety precautions should be taken during installation.

The Bosch Dishrack Roller 00165314 is a genuine OEM part that attaches directly to the rack and allows the lower rack to roll in and out of the dishwasher with ease. Sold individually. Recommended to replace in pairs due to wear and tear. The roller has a diameter of approximately 1.5 inches.

The Bosch Drain Hose 00298564 is a genuine OEM part that carries drain water from the dishwasher to the kitchen sink drain. It is 5 ft. in length and comes with one O-ring. The hose is compatible with various Bosch dishwasher models and replaces several part numbers.

The Bosch Circulation Pump 00442548 is a high-quality OEM part that moves water through the spray arms to clean dishes in various dishwasher models from Bosch, Gaggenau, Thermador, and Kenmore. Disconnect the appliance from all utilities before installation.

Tine clip kit (also called a bearing) for dishwasher dishrack. Includes (2) bearings (2) sleeves and (4) tine clips.

The Bosch Tine Row Clip 00418498 is a high-quality OEM part used in the lower rack of a dishwasher to hold the tine row in place. It allows for the conversion of the rack to accommodate more dishes of different shapes and sizes.

The Bosch Door Latch 00438026 is a high-quality OEM part that keeps the dishwasher door closed during operation. It replaces several other part numbers and is compatible with various Bosch dishwasher models. Safety precautions should be taken during installation.

Door support rope and pulley kit

Dishwasher lower dishrack assembly with wheels. Corroded or rusted dishracks should be replaced to avoid parts of the rack falling down and getting into the circulation pump damaging the pump.

Hinge Bushing Snap Lock

The Bosch Upper Dishrack Slide Rail Stop 00165254 is a high quality, genuine OEM part that prevents the upper dishrack from sliding completely off the slide rail. It includes front and rear rack stops and is compatible with various Bosch dishwasher models.