Washing machine drain pump. The pump mounts directly to the motor with two clips. If the washer does not drain then the pump could be locked up or a small object may be clogging it. A small leak in front of the washer could be caused by a defective pump.
Washing machine suspension spring. If the suspension spring is broken, the washer will be off balance.
Washing machine lid switch assembly with wire harness. The lid switch ensures that the washer door is closed while the washer is spinning. If the lid switch is broken, the washer will not spin. If the washer won't spin but will still agitate, the lid switch is likely defective.
Washing machine water inlet valve kit with bracket. A long or slow fill cycle is often due to a restricted water valve. The valve should never be disassembled and cleaned, only replaced.
Spanner nut wrench for many Whirlpool, Kenmore, General Electric & Maytag inner tub lock (spanner) nuts
Washing machine tub counterbalance spring. This spring offsets the weight of the motor on the front of the washer. If broke, the tub will lean forward and the tub will be off balance during the spin cycle.
Adjustable leveling leg for washing machine. This leveling leg has a rubber foot. If the leveling leg is not adjusted properly, the washer will be off-balance and will vibrate or shake during operation.
Transmission (gearbox) for direct-drive washing machines. If the gears inside the transmission are worn out, the washer may not spin.
Washer drive block for inner tub. A worn drive block may cause the washer to spin slowly, causing the clothes to be soaked at the end of the cycle. The washer may also make a loud knocking noise at the beginning of the spin cycle.
Bleach dispenser cup. Helps to funnel bleach to the bottom of the tub to mix with the water. White