LG Washing Machine WD-11581BD Parts

Washer hot water inlet valve. Standard hose fitting inlet, 1 water outlet. The water inlet valve opens to allow water to enter the washing machine. If the water inlet valve is defective, the wash may fill slowly or not fill at all.

Shock absorber kit

The 6501KW2002B Rotor Position Sensor Assembly is essential for accurately detecting the rotor's position. When this sensor fails, it can trigger an LE error code on the control panel, indicating a malfunction. This sensor is compatible with various Kenmore and LG washer models.

Washing machine door boot gasket with drain port. If the door boot is torn, the washer will leak water. The most common cause of a torn door boot is if the washer is overloaded. Be aware that your model may also list a door boot without drain port. Be sure to check the original part before ordering.

Inlet hose

Washer tub bearing, rear. This part is very difficult to install. The manufacturer recommends replacing the complete rear tub and bearing assembly.

Washing machine tub seal between outer & inner tubs

Rear tub bearing. This part is very difficult to install. The manufacturer recommends replacing the complete rear tub and bearing assembly.

Washing machine tub seal. Located between the front outer tub and rear outer tub. If the washing machine is leaking water from between these two tubs, this seal is likely damaged or worn out.

Washing machine filter and trap assembly.

Shock Retaining Pin

Washing machine drain hose with bellows. This drain hose makes a connection from the washer tub to the drain pump.

Washing machine stator assembly with sensor

Water level pressure switch

Dispenser drawer housing